Dell Force10 S4810P 빠른 시작 매뉴얼 - 페이지 22

{카테고리_이름} Dell Force10 S4810P에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S4810P 27 페이지. Quick start guide

Assign Interfaces to a VLAN

Only interfaces in Layer 2 mode can be assigned to a VLAN using the tagged

and untagged commands. Use the switchport command to place an interface in

Layer 2 mode.

These Layer 2 interfaces can further be designated as tagged or untagged. When

an interface is placed in Layer 2 mode by the switchport command, the

interface is automatically designated untagged and placed in the Default VLAN.

To view which interfaces are tagged or untagged and to which VLAN they

belong, use the show vlan command. To view just the interfaces that are in

Layer 2 mode, enter the show interfaces switchport command in the EXEC

Privilege mode or EXEC mode.

To tag frames leaving an interface in Layer 2 mode, you must assign that

interface to a port-based VLAN to tag it with that VLAN ID. To tag interfaces,

use these commands in the following sequence:

Step Task

Access the

INTERFACE VLAN

mode of the VLAN to

which you want to

assign the interface.

Enable an interface to

include the IEEE

802.1Q tag header.

Use the untagged command to move untagged interfaces from the Default

VLAN to another VLAN:

Step Task

Access the

INTERFACE VLAN

mode of the VLAN to

which you want to

assign the interface.

Installing the Software

Command Syntax

interface vlan vlan-id

tagged interface

Command Syntax

interface vlan vlan-id

Command Mode

CONFIGURATION

INTERFACE

Command Mode

CONFIGURATION