Dell MXG610s 설정 매뉴얼 - 페이지 5

{카테고리_이름} Dell MXG610s에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell MXG610s 13 페이지. Fibre channel switch module
Dell MXG610s에 대해서도 마찬가지입니다: 설정 매뉴얼 (17 페이지)

Topics:

MX7000 chassis preparation

Switch module installation

Serial connection
Optical transceivers and cabling installation
Port-side LEDs
Static IP addresses
Additional country-specific IEEE notices
MX7000 chassis preparation
Before you insert the switch module in the MX7000 chassis, meet the following conditions:
● The chassis is powered up and meets all its specific power requirements.
● The I/O module bay C1 or C2 is empty and ready to receive the switch module.
● If you are replacing an existing switch module, to maintain the proper cooling level in the chassis, insert the replacement
switch module within one minute.
Switch module installation
Insert the switch modules in the MX7000 chassis slots and check that the modules are functioning properly.
NOTE:
The switch module works in slots C1 and C2. Do not insert the switch module in any other slot because this action
may damage the chassis or switch module connector pins.
1. Remove the orange plastic protective cover for the backplane connector.
MXG610s Setup Guide
MXG610s Setup Guide
2
5