Dell N1108T-ON 시작하기 매뉴얼 - 페이지 7
{카테고리_이름} Dell N1108T-ON에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell N1108T-ON 27 페이지.
페이지 인쇄
- 1. Getting Started Guide
- 2. N1100-On Series Hardware Overview
- 3. N1124T-On/N1124P-On/N1148T-On/ N1148P-On Installation
- 4. Starting and Configuring the N1100-On Series Switch
- 5. Connecting an N1100-On Series Switch to a Terminal
- 6. Performing the N1100-On Series Initial Configuration
- 7. Enabling Remote Management
- 8. Initial Configuration Procedure
N1108T-ON/N1108P-ON Installation
Rack Mounting an N1108T-ON/N1108P-ON Switch
WARNING:
as well as the safety information for other switches that connect to or support the
switch.
The AC power connector is on the rear panel of the switch.
Installing in a Rack
WARNING:
table or desk, or attach it to a wall.
CAUTION:
Disconnect all cables from the switch before continuing. Remove all
self-adhesive pads from the underside of the switch, if they have been attached.
CAUTION:
When mounting multiple switches into a rack, mount the switches
from the bottom up.
1 Secure the N1108T-ON/N1108P-ON switch in either the Dell Rack Mount
Kit as shown in Figure 1-1 or the Dell Tandem Tray Kit as shown in
Figure 1-2.
Figure 1-1. Dell Rack Mount Kit
Read the safety information in the
Do not use rack mounting kits to suspend the switch from under a
Safety and Regulatory Information
Getting Started Guide
7