Allied Telesis AT-AR020 PRI E1/T1 설치 매뉴얼 - 페이지 7
{카테고리_이름} Allied Telesis AT-AR020 PRI E1/T1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AT-AR020 PRI E1/T1 13 페이지. Port interface card
Allied Telesis AT-AR020 PRI E1/T1에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지), 데이터시트 (1 페이지), 빠른 설치 매뉴얼 (10 페이지), 설치 및 안전 매뉴얼 (8 페이지)
페이지 인쇄
6
7.
Unpack the PIC.
In an antistatic environment, remove the PIC from its packing material. Be sure
to observe ESD precautions.
Warning Do not attempt to install a PIC or any other expansion option
without observing correct antistatic procedures. Failure to do so may damage
the switch or router, PIC, or expansion option. If you are unsure what the
correct procedures are, contact your authorised Allied Telesis distributor or
reseller.
8.
If the PIC has jumpers, check they are correctly set.
Warning Do not attempt to change any jumpers, DIP switches, or other
hardware configurations while the switch or router is connected to a power
supply, redundant power supply, or a 'live' network. Dangerous voltages may be
present on some parts of the board, even if the switch or router is turned off.
AT-AR020 PRI E1/T1 and AT-AR021(S) BRI-S/T PICs have user-configurable
jumpers. Check all jumpers are set correctly on the new PIC, as shown in
Table 1
jumper. If present, this jumper must be installed for E1 mode and removed for
T1 mode. The AT-AR021(S) V2 hardware revision, identified by the label
"AR021 V2" on the board, supports both TE and NT mode. Jumper J4, when
installed, selects NT mode. The PIC should be configured as a TE for normal
operation.
Table 1: Functions of jumpers on the AT-AR020 PRI E1/T1 PIC board
Jumper
J1
J2
J3
Table 2: Functions of jumpers on the AT-AR021(S) BRI S/T PIC board
Jumper
J1
J2
J4
and
Table
2. Early versions of the AT-AR020 PIC also have a J3 interface
Function
ISDN NT mode (installed, test only) or
TE mode (not installed).
T1 mode (installed) or E1 mode (not installed).
E1 mode (installed) or T1 mode (not installed).
Only present on earlier versions of the PIC.
Function
100Ω termination for TX.
100Ω termination for RX.
ISDN NT mode (installed) or TE mode (not
installed). Only present on V2 hardware revision
of PIC.
Port Interface Card
Default
Not installed.
Installed.
-
Default
Not installed.
Not installed.
Not installed.