Dell Networking N20 Series 설치 매뉴얼 - 페이지 22

{카테고리_이름} Dell Networking N20 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Networking N20 Series 49 페이지.

NOTE:

In the User-Configured Cascade Ports field, A (active) indicates that a C9010 port is up (no shutdown) and configured

as a cascade port; I (inactive) indicates that a port is down and configured as a cascade port.

Dell# show interface port-channel brief

Codes: L - LACP Port-channel

O - OpenFlow Controller Port-channel

A - Auto Port-channel

LAG

Mode

Status

258

N/A

Next Steps

After you complete the initial provisioning, you can configure L2 software features on the N20xx system from the C9010 console CLI,

including LLDP, 802.1x, LACP, loop detection and BPDU Guard. No other L2 protocols are supported. IP address and L3 protocol

configuration on N20xx ports are not supported. For detailed information, see the Dell Networking Configuration Guide for C9000 Series

Switches.

When the N20xx system is online, you can enter the connect pe pe-id command on the C9010 console to remotely log in to the

N20xx CLI. To log in, enter the user name peadmin and the password calvin. After logging in, you can enter show and stack

renumbering commands on the N20xx system.

Uptime

Ports

14:45:26

Te 0/1,2

(up)

Starting and Configuring the N20xx Switch