Dell Networking N4064F 구성 매뉴얼 - 페이지 12

{카테고리_이름} Dell Networking N4064F에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Networking N4064F 17 페이지. Expansion modules for dell networking switches
Dell Networking N4064F에 대해서도 마찬가지입니다: 참조 매뉴얼 (17 페이지)

페이지 인쇄

Configure Data Center Bridging (DCB) (Optional)

DCB is enabled by default. This section shows the steps required to configure DCB.

Note: You must complete the Dell recommended switch configuration steps in Sections 2.1 to 2.12

before configuring the switch for DCB mode.

3.1

Enable DCB

If DCB was previously disabled, it must be manually re-enabled.

console#configure

console(config)#dcb enable

3.2

Create VLAN

console#configure

console(conf)# vlan vlan-id

Note: You must supply a VLAN id. The valid range is 2-4093.

console(conf)#exit

3.3

Configure class of service, dot1p mapping, and traffic class

console(config)#iscsi cos enable

console(config)#iscsi cos vpt 4

console(config)#classofservice dot1p-mapping 4 4

console(config)#classofservice traffic-class-group 4 1

3.4

Configure Priority flow control on switch ports and port channel

console(config)#interface range tengigabitethernet all

console(config-if)#datacenter-bridging

console(config-if-dcb)#priority-flow-control mode on

console(config-if-dcb)#priority-flow-control priority 4 no-drop

console(config-if-dcb)#exit

console(config-if)#switchport mode trunk

SCG1001

Dell Networking N4000 Series and Dell PowerConnect 8100 Series Configuration Guide