Dell Networking S4810 구성 매뉴얼 - 페이지 5

{카테고리_이름} Dell Networking S4810에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Networking S4810 17 페이지. Open networking
Dell Networking S4810에 대해서도 마찬가지입니다: 사양 (2 페이지), 구성 매뉴얼 (17 페이지), 설치 매뉴얼 (42 페이지), 시작하기 매뉴얼 (16 페이지)

페이지 인쇄

Introduction

This document illustrates how to configure Dell™ Networking S4810 and Dell Force10™ S4810 switches

for use with EqualLogic™ PS Series storage using Dell best practices. The recommended configuration

uses link aggregation groups (LAGs) for inter-switch connections. Optional steps are provided in Section 3

to enable Data Center Bridging (DCB) and for stack configurations.

If you are following the Rapid EqualLogic Configuration steps at

http://en.community.dell.com/techcenter/storage/w/wiki/3615.rapid-equallogic-configuration-portal-

by-sis.aspx, use sections 1 and 2, or 1 and 5 in this Switch Configuration Guide.

For more information on EqualLogic SAN design recommendations, see the EqualLogic Configuration

Guide at: www.delltechcenter.com/page/equallogic+configuration+guide.

1.1

Audience

This switch configuration guide describes an optimal configuration following Dell best practices for an

EqualLogic iSCSI SAN and is intended for storage or network administrators and deployment personnel.

1.2

Switch details

The table below provides an overview of the switch configuration.

Table 1

Dell Networking and Dell Force10 S4810

Switch vendor

Switch model

Switch firmware

Note: For proper functionality, the switch must be at the switch firmware version shown in the table

above before proceeding with this configuration. Using previous firmware versions may have

unpredictable results.

The latest firmware updates and documentation can be found at: www.force10networks.com. This site

requires a login.

SCG1000 | Dell Networking S4810 and Force10 S4810 Configuration Guide for EqualLogic SANs

Switch specifications

Dell

S4810

9.9.0.0 or later