Dell Networking S5000 설치 매뉴얼 - 페이지 26

{카테고리_이름} Dell Networking S5000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Networking S5000 50 페이지. Data center switch
Dell Networking S5000에 대해서도 마찬가지입니다: 구성 매뉴얼 (12 페이지), 구성 매뉴얼 (17 페이지), 시작하기 매뉴얼 (37 페이지)

페이지 인쇄

Figure 12. Installing an Ethernet Module

1. Release latch

2. Ethernet Module

Replacing an Ethernet Module

NOTE: S5000 does not support the hot swapping of an Ethernet pluggable module during switch operations.

Instead, you must power down the switch before removing and replacing an expansion module.

Disconnect any network interface cables attached to the module.

Use the grab handle to slide the Ethernet module out of the switch module slot.

Use the grab handle on the replacement Ethernet module to slide it into the switch module slot.

Connect any network interface cables to the attached module.

Important Points to Remember for Installing a Fibre Channel

Module

•

You must insert the Fibre Channel module only in slot 0.

•

Installing and swapping of Fibre Channel modules must be done BEFORE power up. If you need to install or

replace a module, power down the system before you install or replace it. If you install or replace a module

when the system is powered up, the system does not recognize the module. Online insertion of modules can

result in a catastrophic failure.

•

The S5000 does not support the hot swapping of a Fibre Channel pluggable module during switch operations.

Instead, you must power down the switch before removing and replacing a Fibre Channel module.

•

Although the handle and port numbering may appear differently on a Fibre Channel module, there is no

functional difference. A module may have:

–

A larger handle that covers the entire front of the module and has the part number written on top of the

handle. Port numbering is written on the front of the handle.

–

A smaller handle that is half the size and does not cover the release button. The part number is written

on the front of the handle. Port numbering is written on the lower part of the front of the module.