Dell Networking X1052P 시작하기 매뉴얼 - 페이지 8

{카테고리_이름} Dell Networking X1052P에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Networking X1052P 43 페이지.

3 Make sure that the switch has proper ventilation.

Wall Installation

To mount the switch on a wall:

1 Make sure that the mounting location meets the following requirements:

•

The surface of the wall must be capable of supporting the switch.

•

Allow at least two inches (5.1 cm) space on the sides for proper

ventilation and five inches (12.7 cm) at the back for power cable

clearance.

•

The location must be ventilated to prevent heat buildup.

2 Place the supplied wall-mounting bracket on one side of the switch,

verifying that the mounting holes on the switch line up to the mounting

holes on the wall-mounting bracket.

Figure 1-2. Bracket Installation for Wall Mounting

3 Insert the supplied screws into the wall-mounting bracket holes and

tighten with a screwdriver.

4 Repeat the process for the wall-mounting bracket on the other side of the

switch.

5 Place the switch on the wall in the location where the switch is being

installed.

Getting Started Guide