Dell Networking Z9500 설치 매뉴얼 - 페이지 36
{카테고리_이름} Dell Networking Z9500에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Networking Z9500 47 페이지. Z9500 switch
Dell Networking Z9500에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (34 페이지)
페이지 인쇄
WARNING: When working with optical fibres, follow all the warning labels and always wear eye
protection. Never look directly into the end of a terminated or unterminated fibre or connector
as it may cause eye damage.
1.
Position the optic so it is in the correct position. The optic has a key that prevents it from being
inserted incorrectly.
2.
Insert the optic into the port until it gently snaps into place.
Port Numbering Convention
On the switch, all ports operate by default in 40GbE mode. If you use a breakout cable, each port can
operate in 4x10GbE mode.
Ports are located on three line cards as shown below. The line cards are factory-installed and are not
hot-swappable or field-replaceable. On each line card, the fixed 40GbE ports are numbered from bottom
to top in multiples of four, starting with zero; for example, 0, 4, 8, 12, and so on. When a breakout cable is
installed, the resulting four 10GbE ports are numbered with the remaining numbers. For example, 40GbE
port 0 contains 10GbE ports 0, 1, 2, and 3; 40GbE port 4 contains 10GbE ports 4, 5, 6, and 7.
Line card 0 consists of ports 0 to 143; line card 1 consists of ports 0 to 191; line card 2 consists of ports 0
to 191.
Figure 14. Port Numbering
Splitting QSFP+ Ports to SFP+ Ports
The system supports splitting a single 40GbE QSFP+ port into four 10GbE SFP+ ports using one of the
supported breakout cables.
For a list of supported optics, contact your Dell Networking representative or reseller.
•
Configure the system to recognize the port mode change.
CONFIGURATION mode
linecard number port number portmode quad
– port <number>- Enter the port number of the 40GbE port to be split. The range is 48 to 60.
36
Z9500 Installation