Dell PowerConnect 28 SERIES 시작하기 매뉴얼 - 페이지 20

{카테고리_이름} Dell PowerConnect 28 SERIES에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 28 SERIES 22 페이지.

1 Connect the switch to a PC via Ethernet, and set a static IP address of 192.168.2.x 255.255.255.0

(where x is between 2 and 254) on the PC.

2 Connect to the switch using IP address 192.168.2.1 in your web browser. The login is: username =

admin with no password.

3 After connecting to the device, use the IP Interface Parameters page to define the required IP

address (static or DHCP) for the device and its default gateway.

4 After the device is configured with new IP address, connect the device to the network or to a PC with

the correct subnet settings and continue configuring it via web management.

5 The IP Addressing page contains a link to the IP Interface Parameters page that is used to assign the

device IP address, subnet mask and default gateway, and for enabling or disabling DHCP. In the web

management interface navigation menu at left, select the System > IP Addressing > IP Interface

Parameters screen.

Figure 3-3. Web management IP Interface Parameters

6 Enter the IP Address, Subnet Mask and Default Gateway.

7 Click Apply Changes. The device is configured.

Retrieving an IP Address From a DHCP Server

The device can be set to receive its IP address from a DHCP server. In this case, the configuration

received from the DHCP server includes the IP address, and might include subnet mask and default

gateway.

When using the DHCP protocol to retrieve an IP address, the device acts as a DHCP client. When the

device is reset, the DHCP command is saved in the configuration file, but not the IP address.

Starting and Configuring the Device