Allied Telesis AT-AR023 SYN 설치 및 안전 매뉴얼 - 페이지 4

{카테고리_이름} Allied Telesis AT-AR023 SYN에 대한 설치 및 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AT-AR023 SYN 8 페이지. Port interface card
Allied Telesis AT-AR023 SYN에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지), 설치 매뉴얼 (13 페이지), 데이터시트 (1 페이지), 빠른 설치 매뉴얼 (10 페이지)

페이지 인쇄

Installing a PIC

This section describes the procedure for installing a PIC. Follow the same

procedures, in particular the safety procedures and warnings, to replace or remove

a PIC.

1. Read the safety information.

For safety information, see the Installation and Safety Guide for your switch or

router. A copy of this guide can be found on the CD-ROM that came with your

switch or router, or at

2. Gather the tools and equipment you will need.

A medium-sized flat-bladed screwdriver may be useful when loosening the PIC

thumbscrews. You should also have any cables required for connecting the PIC

to a wide area network or other network devices.

3. Remove power to the switch or router.

Warning Do not install a PIC into an NSM bay or PIC bay base unit without first

removing power from the switch or router. Be sure to disconnect both the main

power supply and any attached redundant power supply. Installing a PIC with the

switch or router powered ON can damage the PIC, NSM and base unit.

4. Remove all TNV connections to existing PICs.

Warning Remove any cables attached to the external WAN ports of the

AR020, AR021 and AR027 PICs, as these supply TNV into the switch or router.

Dangerous voltages may be present on some parts of the board, even if the

switch or router is powered OFF.

5. Install the AR040 NSM if required.

Use the installation instructions in the Network Service Module Installation and

Safety Guide to install an AR040 NSM.

6. Remove the PIC-bay faceplate, NSM PIC-bay faceplate, or existing

PIC.

Loosen the thumbscrews to remove the faceplate or PIC. Keep the faceplate for

future use. If you remove the PIC, replace the faceplate to prevent dust and

debris from entering the switch or router and to maintain proper airflow.

613-000601 Rev A

www.alliedtelesis.com/support/software/

Port Interface Card