Dell PowerConnect 7024P 펌웨어 업그레이드 - 페이지 24
{카테고리_이름} Dell PowerConnect 7024P에 대한 펌웨어 업그레이드을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 7024P 24 페이지. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect 7024P에 대해서도 마찬가지입니다: 릴리스 정보 (27 페이지)
페이지 인쇄
Upgrading PowerConnect Switches from Version 2.x.x.x or 3.x.x.x or
4.x.x.x or 5.x.x.x to 5.1.9.3 Firmware
8. Verify that the 5.1.9.3 version of firmware is loaded on the switch. The switch or stack is now ready for
normal operation. Verify the configuration and make any changes needed prior to connecting the switch to
the operational network.
Firmware Downgrade
Downgrading from 5.1.9.3 to an earlier release is supported on all PowerConnect series switches. But migration of
configuration information from a later release to an earlier release is not supported. The existing configuration may
or may not work with downgraded firmware, therefore, it is best to be physically present at the switch site and to be
prepared to access the switch over the serial port if necessary when downgrading firmware.
Auto-downgrade of a stack is enabled by default. To avoid accidentally downgrading a stack, be sure to disable
auto-downgrade (CLI command: no boot auto-copy-sw allow-downgrade).
Boot Code Downgrade
Never downgrade the boot code! The 5.1.9.3 boot code supports all earlier versions of firmware and never needs
downgrading.
Hardware Supported
Dell PowerConnect M6220 Ethernet Switch
Dell PowerConnect M6348 Ethernet Switch
Dell PowerConnect 8024 Ethernet Switch
Dell PowerConnect 8024F Ethernet Switch
Dell PowerConnect M8024 Ethernet Switch
Dell PowerConnect M8024-K Ethernet Switch
Dell PowerConnect 7024 Ethernet Switch
Dell PowerConnect 7048 Ethernet Switch
Dell PowerConnect 7024P Ethernet Switch
Dell PowerConnect 7048P Ethernet Switch
Dell PowerConnect 7024F Ethernet Switch
Dell PowerConnect 7048R Ethernet Switch
Dell PowerConnect 7048R-RA Ethernet Switch
End of document
Page 21