Dell PowerConnect 7048 펌웨어 업그레이드 - 페이지 10

{카테고리_이름} Dell PowerConnect 7048에 대한 펌웨어 업그레이드을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 7048 24 페이지. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect 7048에 대해서도 마찬가지입니다: 릴리스 정보 (27 페이지)

페이지 인쇄

Upgrading PowerConnect Switches from Version 2.x.x.x or 3.x.x.x or

4.x.x.x or 5.x.x.x to 5.1.9.3 Firmware

- # of sectors per FAT copy:

- # of FAT table copies:

- # of hidden sectors:

- first cluster is in sector #

- Update last access date for open-read-close = FALSE

PCI unit 0: Dev 0xb820, Rev 0x11, Chip BCM56820_B0, Driver BCM56820_A0

SOC unit 0 attached to PCI device BCM56820_B0

Adding BCM transport pointers

Configuring CPUTRANS TX

Configuring CPUTRANS RX

Instantiating /download as rawFs,

Formatting /download for DOSFS

Instantiating /download as rawFs, device = 0x20001

Formatting.../download: file system is marked clean, skipping check

OK.

<186> Apr 6 03:09:42 0.0.0.0-1 General[1073741072]: bootos.c(225) 1 %% Event(0xaaaaaaaa)

Instantiating RamCP: as rawFs,

Formatting RamCP: for DOSFS

Instantiating RamCP: as rawFs, device = 0x30001

RamCP:/

- disk check in progress ...

RamCP:/

- Volume is OK

OK.

(Unit 1 - Waiting to select management unit)>

Applying Global configuration, please wait ...

Applying Interface configuration, please wait ...

console>

6. After the switch has finished rebooting, log in and verify that the firmware has been updated to the

version using the show version command. A single switch will typically reboot in around two minutes. A

stack may take significantly longer to complete the upgrade process.

console#show version

System Description................ Dell Ethernet Switch

System Up Time.................... 0 days, 00h:02m:36s

System Contact....................

System Name.......................

System Location...................

Burned In MAC Address............. 5C26.0AB2.4327

System Object ID.................. 1.3.6.1.4.1.674.10895.3023

System Model ID................... PC8024

Machine Type...................... Powerconnect 8024

unit image1

---- ----------- ----------- -------------- --------------

4.2.1.3

7. The switch is now ready for normal operation. Verify the configuration and make any changes needed prior

to connecting the switch to the operational network.

NOTE:

After upgrading to the 5.1.9.3 firmware, one can emulate the earlier

firmware default behavior for privileged exec (enable) mode access by

setting the enable authentication method to enableList.

console(config)# line telnet

console(config)# enable authentication enableList

console(config)# exit

136

device = 0x20001

device = 0x30001

image2

current-active next-active

5.1.9.3

image2

Page 7

5.1.9.3