Dell PowerConnect 8024F 릴리스 정보 - 페이지 6
{카테고리_이름} Dell PowerConnect 8024F에 대한 릴리스 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 8024F 20 페이지. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect 8024F에 대해서도 마찬가지입니다: 릴리스 정보 (27 페이지), 구성 매뉴얼 (21 페이지), 구현 매뉴얼 (8 페이지), 펌웨어 업그레이드 (24 페이지)
페이지 인쇄
PowerConnect 8024/8024F Release Notes
Features Introduced in this Release
Release 3.1.4.16
No new features introduced in Release 3.1.4.16.
Release 3.1.4.8
No new features introduced in Release 3.1.4.8.
Release 3.1.4.5
New PowerConnect 8024 Switch
A 24 port 10GBase-T (1Gigabit/10Gigabit) switch with 20 fixed 10GBase-T ports and 4 combo ports that
can be either 10GBase-T or SFP/SFP+. There are two redundant power supplies each of which can supply
300W. For management there is one RS232 console port and an OOB port.
Fiber ports support 1Gigabit and 10Gigabit Transceivers
The PC8024/PC8024F support 1Gigabit SFP and 10Gigabit SFP+ transceivers on fiber ports. The following
table explains the supported transceivers and their capabilities on fiber ports.
Module Type
SFP
SFP+
RTAG7 Hashing Mode Support
Port Channels now can use the RTAG7 hashing support for improved load sharing.
There are several configurable RTAG7 options such as packet field selection, source and destination port
numbers, XOR and CRC algorithms, and modulo operation. The RTAG7 settings apply to both Trunk
hashing and ECMP hashing. There cannot be 2 different RTAG7 settings for LAGs and ECMP.
Page 4
Negotiation Support
Yes
No
Default Negotiation
Enabled
Not Applicable
System Firmware Version 3.1.4.16
Supported Speeds
1G
10G