Dell PowerConnect 8024F 펌웨어 업그레이드 - 페이지 22
{카테고리_이름} Dell PowerConnect 8024F에 대한 펌웨어 업그레이드을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 8024F 24 페이지. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect 8024F에 대해서도 마찬가지입니다: 릴리스 정보 (27 페이지), 릴리스 정보 (20 페이지), 구성 매뉴얼 (21 페이지), 구현 매뉴얼 (8 페이지)
페이지 인쇄
Upgrading PowerConnect Switches from Version 2.x.x.x or 3.x.x.x or
4.x.x.x or 5.x.x.x to 5.1.9.3 Firmware
Switch Recovery Example
1. Connect a serial cable to the serial port (8-No Parity-1-9600-No Flow Control)
2. Power cycle the switch
3. When the boot menu appears, select 2 – Start Boot Menu
Boot Menu 3.1.4.5
Select an option. If no selection in 10 seconds then
operational code will start.
1 - Start operational code.
2 - Start Boot Menu.
Select (1, 2):2
Boot Menu 3.1.4.5
Options available
1
- Start operational code
2
- Change baud rate
3
- Retrieve event log using XMODEM
4
- Load new operational code using XMODEM
5
- Display operational code vital product data
6
- Abort boot code update
7
- Update boot code
8
- Delete backup image
9
- Reset the system
10 - Restore configuration to factory defaults (delete config files)
11 - Activate Backup Image
12 - Password Recovery Procedure
13 - Reformat and restore file system
4. If not already loaded, download the firmware to the switch using Xmodem 1K block size (Select option
Load new operational code using XMODEM).
Microsoft Windows®. Information on how to operate HyperTerminal can be obtained here:
http://technet.microsoft.com/en-us/library/cc784492%28WS.10%29.aspx
Boot Menu 3.1.4.5
Options available
1
- Start operational code
2
- Change baud rate
3
- Retrieve event log using XMODEM
4
- Load new operational code using XMODEM
5
- Display operational code vital product data
6
- Abort boot code update
7
- Update boot code
8
- Delete backup image
9
- Reset the system
10 - Restore configuration to factory defaults (delete config files)
11 - Activate Backup Image
12 - Password Recovery Procedure
13 - Reformat and restore file system
[Boot Menu] 4
Ready to receive the file with XMODEM/CRC....
Ready to RECEIVE File xcode.bin in binary mode
Send several Control-X characters to cancel before transfer starts.
HyperTerminal supports Xmodem-1K and is distributed with
Page 19
4 -