Dell PowerConnect 8100 Series 구성 매뉴얼 - 페이지 12

{카테고리_이름} Dell PowerConnect 8100 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 8100 Series 17 페이지. Powerconnect 8100 series high-performance 10/40 gbe enterprise switches
Dell PowerConnect 8100 Series에 대해서도 마찬가지입니다: 사양 (3 페이지)

Dell PowerConnect 8100 Series 구성 매뉴얼
3

Configure Data Center Bridging (DCB) (Optional)

DCB is enabled by default. This section shows the steps required to configure DCB.
Note: You must complete the Dell recommended switch configuration steps in Sections 2.1 to 2.12
before configuring the switch for DCB mode.
3.1

Enable DCB

If DCB was previously disabled, it must be manually re-enabled.
console#configure
console(config)#dcb enable
3.2

Create VLAN

console#configure
console(conf)# vlan vlan-id
Note: You must supply a VLAN id. The valid range is 2-4093.
console(conf)#exit
3.3

Configure class of service, dot1p mapping, and traffic class

console(config)#iscsi cos enable
console(config)#iscsi cos vpt 4
console(config)#classofservice dot1p-mapping 4 4
console(config)#classofservice traffic-class-group 4 1
3.4

Configure Priority flow control on switch ports and port channel

console(config)#interface range tengigabitethernet all
console(config-if)#datacenter-bridging
console(config-if-dcb)#priority-flow-control mode on
console(config-if-dcb)#priority-flow-control priority 4 no-drop
console(config-if-dcb)#exit
console(config-if)#switchport mode trunk
12
SCG1001
Dell Networking N4000 Series and Dell PowerConnect 8100 Series Configuration Guide