Allied Telesis AT-AR027 VoIP-FXS 설치 매뉴얼 - 페이지 9
{카테고리_이름} Allied Telesis AT-AR027 VoIP-FXS에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AT-AR027 VoIP-FXS 13 페이지. Port interface card
Allied Telesis AT-AR027 VoIP-FXS에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지), 데이터시트 (1 페이지), 데이터시트 (1 페이지), 빠른 설치 매뉴얼 (10 페이지), 설치 및 안전 매뉴얼 (8 페이지)
페이지 인쇄
8
Setting the ISDN Territory
Before you connect an AT-AR020 or AT-AR021 PIC to the ISDN network, check
that the ISDN territory is set correctly for your region.
1.
Log in to your switch or router.
For more information, see the Installation and Safety Guide included with your
switch or router. You can also download the complete documentation for your
switch or router from www.alliedtelesis.com/support/software/.
2.
Set the territory, using the command:
set system territory={australia|china|europe|japan|korea|
newzealand|usa}
In Australia only:
• To use the Micro service, set the territory to australia.
• To use the OnRamp service, set the territory to europe.
3.
Save the configuration.
Save your configuration to a new file by using the command:
create config=filename.cfg
Then set the router to load this file when it restarts by using the command:
set config=filename.cfg
We recommend leaving the boot.cfg file unchanged, in case you need to revert
to the original default configuration.
See the AlliedWare
configuring ISDN.
®
Operating System Software Reference for more information on
Port Interface Card