Dell PowerConnect 8132F 구성 매뉴얼 - 페이지 16

{카테고리_이름} Dell PowerConnect 8132F에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 8132F 17 페이지. Powerconnect 8100 series high-performance 10/40 gbe enterprise switches
Dell PowerConnect 8132F에 대해서도 마찬가지입니다: 사양 (3 페이지)

페이지 인쇄

4.2

Revert to default VLAN ID on switch and arrays

Once DCB is disabled on the switch, the EqualLogic arrays will no longer use the VLAN ID that was

configured when DCB was enabled. The arrays will revert to the default or native VLAN. Therefore, a valid

VLAN must be configured for all host servers, switches, and EqualLogic array members. A valid VLAN can

use the default or native VLAN ID (typically 0 or 1) or a specific VLAN can be configured (for example,

VLAN 100). If a non-default VLAN is configured, then any ports connected to the arrays must be

configured as "untagged".

Use the steps below to configure the native VLAN on the switch.

console#configure

console(config)#interface range tengigabitethernet all

console(config-if)#no switchport mode

console(config-if)#exit

console(config)#interface range fortygigabitethernet all

console(config-if)#no switchport mode

console(config-if)#exit

console(config)#interface port-channel 1

console(config-if)#no switchport mode

console(config-if)#exit

console(config)#no vlan vlan-id

console(config)#exit

4.3

Save configuration

console# copy running-config startup-config

This operation may take a few minutes.

Management interfaces will not be available during this time.

Are you sure you want to save? (y/n)y

4.4

Configure additional switch

Repeat the commands from Section 4 to disable DCB on any additional switches.

SCG1001

Dell Networking N4000 Series and Dell PowerConnect 8100 Series Configuration Guide