Dell PowerConnect BI-RX-4 시작하기 매뉴얼 - 페이지 29

{카테고리_이름} Dell PowerConnect BI-RX-4에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect BI-RX-4 32 페이지. Powerconnect b-rx series

페이지 인쇄

Configuring IP addresses

The PowerConnect B-RX Series switches implement separate data and control planes. This architecture affects how

you assign IP addresses.

Table 3

In this table, "in band" refers to an interface over which user packets are routed, while "out of band" refers to an

interface over which control packets related to system management are forwarded.

TABLE 3

Assigning IP addresses

Interface

Management interface

Any interface over which user packets

are routed

Any virtual interface over which user

packets are routed

Loopback interface

This section describes the following:

•

PowerConnect B-RX Series support of sub-net masks

•

How to assign an IP address to a management interface

•

How to assign an IP address to an interface or virtual interface over which user packets are routed

Support of sub-net masks

The PowerConnect B-RX Series switch supports both classical IP network masks (Class A, B, and C sub-net masks,

and so on) and Classless Interdomain Routing (CIDR) network prefix masks.

•

To enter a classical network mask, enter the mask in IP address format. For example, enter

"209.157.22.99 255.255.255.0" for an IP address with a Class-C sub-net mask.

•

To enter a prefix number for a network mask, enter a forward slash (/) and the number of bits in the mask

immediately after the IP address. For example, enter "209.157.22.99/24" for an IP address that has a network

mask with 24 significant ("mask") bits.

Assigning an IP address to a management interface

Instead of assigning a global IP address to the PowerConnect B-RX Series switch for system management purposes,

you now assign an IP address to the management interface. The IP address is assigned to the active management

module port. If the active management module becomes unavailable and the redundant module becomes the active

module, the IP address is assigned to the new active management module port.

For example, to assign the IP address 10.0.1.1 to the management interface, do the following:

1. At the opening CLI prompt, enter enable.

BigIron RX> enable

PowerConnect B-RX Series Getting Started Guide

53-1001682-03

outlines the interfaces to which you can assign IP addresses.

Associated physical port

Ethernet 10/100/1000 port on active or

redundant management module

Any interface module port

Any interface port

–

Out of band or

in band

Out of band

In band