Dell PowerConnect M8024 구성 매뉴얼 - 페이지 11

{카테고리_이름} Dell PowerConnect M8024에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect M8024 21 페이지. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect M8024에 대해서도 마찬가지입니다: 릴리스 노트 (9 페이지), 릴리스 정보 (27 페이지), 펌웨어 업그레이드 (24 페이지)

페이지 인쇄

3.2

Hardware configuration

Ensure the blade chassis and switch modules are powered on.

2. Connect a serial cable to the serial port of the first switch or optionally use the Chassis Management

Controller (CMC) to connect to the switch module.

3. Using Putty or another terminal utility, open a serial connection session to the switch.

4. Open your terminal emulator and configure it to use the serial port (usually COM1, but this may vary

depending on your system). Configure serial communications for 9600,N,8,1 and no flow control.

5. Connect the LAG cables between the switches. See this configuration in Figure 2.

3.3

Check firmware version

console>enable

console#show version

Note: If the active version displayed here is not 5.1.1.7 or later, please visit support.dell.com and

download the latest update for your switches.

3.4

Delete startup configuration

Note: All configuration settings will be deleted

console#clear config

console>enable

console#copy running-config startup-config

console#reload

Are you sure you want to reload the stack? (y/n) y

Note: The switch will reboot.

SCG1008

PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs