Dell PowerConnect M8024-F 구성 매뉴얼 - 페이지 12

{카테고리_이름} Dell PowerConnect M8024-F에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect M8024-F 21 페이지. For equallogic sans

3.5

Check current operational mode

Note: Before proceeding, the "System Operational Mode" must be set to "Normal". Some switches, such

as the M8024k, ship from the factory in simple mode.

console>enable

console#configure

console(config)#no mode simple

Switching modes will immediately clear the configuration.

to continue? (y/n) y

Switch has unsaved changes.

Are you sure you want to continue? (y/n) y

Note: The switch will reboot. If the switch reports "Normal mode already active", then you may proceed

to the next step without rebooting.

3.6

Note: The PowerConnect M8024-k switches do not support Enhanced Transmission Selection (ETS),

therefore Data Center Bridging (DCB) must be manually disabled using the following steps. If you have

the M8024 switch, skip this section.

console>enable

console#configure

console(config)#no dcb enable

3.7

console(config)#interface out-of-band

console(config-if)#ip address ipaddress mask gateway

console(config-if)#exit

3.8

console(config)#line telnet

console(config-telnet)#login authentication default

console(config-telnet)#exit

SCG1008

PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs

Are you sure you want