Dell PowerConnect PC7048R-RA 기술 백서 - 페이지 32
{카테고리_이름} Dell PowerConnect PC7048R-RA에 대한 기술 백서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect PC7048R-RA 34 페이지. Stacking gigabit ethernet switches
Dell PowerConnect PC7048R-RA에 대해서도 마찬가지입니다: 스태킹 지침 (37 페이지)
Stacking Dell PowerConnect 7000 Series Switches
NSF Re-convergence Timing
As mentioned in the previous section, NSF protects against failures by check-pointing information to a
standby unit. In an NSF-protected stack, the worst-case scenario is when the master unit fails. The
following statistics show representative re-convergence times of an NSF-enabled standby switch as
measured from the detection of failure. With NSF enabled, data plane forwarding continues non-stop
on the non-failed switches while the standby unit converges the control plane protocols using the
check-pointed information. The re-convergence times given below include re-establishing
communication with the upper layer protocol peers, synchronization of shared information with the
peer, and re-establishment of any data plane forwarding paths around the failed master unit.
Medium Configuration
•
8 switches stacked
•
100 VLANs, all ports are members of all VLANs
•
4/4 static/dynamic lags with 8 members each
•
3 MSTP instance with VLANs
•
30 ACLs applied on 30 interfaces
•
10 Diffserv service interfaces with policies on 10 interfaces
•
6 VLAN routing interfaces
•
128 L2 Multicast group entries
•
512 ARP entries
•
128 Unicast routes
Parameter
L2 loss duration (non-failed or rerouted stack member)
L2 loss duration (failed/rerouted stack member)
L3 loss duration (failed/rerouted stack member)
IPMC loss duration (failed/rerouted stack member)
L2 convergence time
L3 convergence time
IPMC convergence time
Total convergence time
Timing
0 msec
10 msec
12 msec
12 msec
25.70 sec
25.410 sec
25.420 sec
25.420 sec
Page 30