Dell PowerConnect W-7200 Series 설치 매뉴얼
{카테고리_이름} Dell PowerConnect W-7200 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect W-7200 Series 4 페이지. Fan tray
페이지 인쇄Dell PowerConnect W-7200 Series Fan Tray
Installation Guide
The Dell PowerConnect W-7200 Series controller is equipped with a field-replaceable, hot-swappable fan tray.
Each fan tray features four individual fans that pull air through the chassis from the front and sides through to
the rear. Each fan tray can tolerate the failure of a single fan while maintaining a safe operating temperature for
the controller.
Hot Swapping
Hot swapping allows you to replace a failed fan tray, making it unnecessary to shut down the W-7200 Series
controller during the replacement procedure.
Figure 1 Fan Tray
Callout
1
2
3
Installing and Removing a Fan Tray
NOTE: Use standard ESD precautions when installing or removing a fan tray module.
The fan tray is field-replaceable and hot-swappable. Hot-swapping allows you to replace the fan tray without
having to power down the W-7200 Series controller.
1. Remove the old fan tray.
a. Using a Phillips Head screwdriver, turn the hinged captive screws counter-clockwise until loose (they
cannot be removed completely).
b. Firmly grasp both of the hinged captive screws and pull the spring loaded hinge down until you are sure
the hinges are disengaged. Use the fan tray handle to pull the fan out.
0511262-01 | January 2013
1
Component
Left Latch
Right Latch
Handle
Description
Used to secure the left side of the fan tray to the chassis.
Used to secure the right side of the fan tray to the chassis.
Used to insert and remove the fan tray from the chassis.
2
3
1