Dell PowerConnect W-AP124 설치 매뉴얼 - 페이지 4

{카테고리_이름} Dell PowerConnect W-AP124에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect W-AP124 13 페이지. Powerconnect w-ap120 series ap
Dell PowerConnect W-AP124에 대해서도 마찬가지입니다: 매뉴얼 (10 페이지)

페이지 인쇄

Installing the AP

Caution: Installation and service of Dell Networks products should be performed by Professional Installers. Additional antenna

and transmit power information for Professional Installers can be found at https://support.dell.com.

Using the Integrated Wall-Mounting Slots

The keyhole-shaped slots on the back of the AP can be used to attach the device upright to an indoor wall or shelf.

When you choose the mounting location, allow additional space at the right of the unit for cables.

Note: For product dimensions, see

of the installed unit for cables, and make sure enough space is available for antenna articulation.

1. At the mounting location, install two screw on the wall or shelf, 1 7/8 inches (4.7 cm) apart. If you are

attaching the device to drywall, Dell recommends using appropriate wall anchors (not included).

2. Align the mounting slots on the rear of the AP over the screws and slide the unit into place (see

Figure 2

3. On the W-AP121 or W-AP125, orient the antennas. For best performance, swivel the antennas so that they

are oriented vertically, preferably in the same plane, parallel to the wall (see

Figure 3

On the W-AP120 or W-AP124, install the external antennas according to the manufacturer's instructions,

and connect the antennas to the antenna interfaces on the AP (see

Product Specifications

Installing the W-AP120 Series Access Point on a Wall

Antenna Orientation on a Wall-Mounted W-AP121/W-AP125

in this guide. Allow 2 inches (5 cm) of additional space at the right side

Figure

Dell PowerConnect W-AP120 Series AP | Installation Guide

Figure

3).

4).

2).