AVX AVX-1600 매뉴얼
{카테고리_이름} AVX AVX-1600에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AVX AVX-1600 2 페이지. Premium audio video controls
페이지 인쇄Premium Audio Video Controls
Engineered in the USA
AVX-1600, AVX-1602, AVX-1604 Speaker Selectors
Features
AVX-1600
1
signal into multiple zones. These models include a manually activated impedance protection circuit that can be turned
ON to prevent the impedance presented to your receiver from dropping below an unsafe level of 5 Ohms, regardless
of the number and impedance ratings of your speakers. The protecting switch can also be turned o
part of a planned system of impedance matching volume controls, allowing you to get
If you are unsure, consult a professional contractor.
Connecting Speaker Selector
The terminals on the rear of the speaker selector will accommodate 14 gauge cable which
connections (greater than 100 feet of wire). For shorter distances, 16- or 18-gauge wire will suf
wall installations, we recommend using UL Class 2 or Class 3 approved cable (marked
this, be sure that the wire attached to the +, red, or positive terminal on the speaker connects to the +, red, or positive
terminal on the rear of the selector box. Similarly , the -, black, or negative terminal on the speaker must connect to the
respective -, black, or negative terminal on the selector box. Polarity should also be maintained when connecting your
Connecting Speaker Cables
selector.
2. Try to make sure all small speaker wire strands are inserted into the opening. Stray speaker
wire strands can cause shorts and damage equipment. Strip 3/8 " insulation from the end of
the cable and twist the exposed end to avoid fraying.
3. Press on a " push-pin " terminal to reveal an eye into which the twisted cable is inserted;
release the terminal to lock.
2
3
Zone Buttons
Push-pin Terminals
r boxes that allow you to distribute a
e selector box.
AV-EXPRESS.COM
4
CL2 or CL3 ) for compliance
r , it is important to retain the correct polarity . To do
IMPEDANCE
PROTECTION
Front
Rear
when used as
n long
-
"
"
3/8
"
r .