Dell PowerEdge M420 기술 매뉴얼 - 페이지 23

{카테고리_이름} Dell PowerEdge M420에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge M420 46 페이지. Dell poweredge blade servers getting started guide
Dell PowerEdge M420에 대해서도 마찬가지입니다: 정보 업데이트 (38 페이지), 릴리스 정보 (27 페이지), 매뉴얼 (25 페이지), 사용자 설명서 (23 페이지), 중요 정보 매뉴얼 (35 페이지), 업데이트 매뉴얼 (32 페이지), 업데이트 매뉴얼 (28 페이지), 사용자 설명서 (26 페이지), 사용자 설명서 (22 페이지), 시작하기 매뉴얼 (12 페이지), 매뉴얼 (38 페이지), 기술 매뉴얼 (48 페이지), 포트폴리오 매뉴얼 (27 페이지), 시작하기 매뉴얼 (14 페이지), 시작하기 매뉴얼 (12 페이지)

The Dell PowerEdge M420 offers balanced, scalable I/O capabilities, including one integrated PCIe

3.0 capable mezzanine card slot.

With M420, the job of deploying, updating, and monitoring is fast and easy. System management

integration features include the following:

Pre-boot: Use the Dell Lifecycle Controller graphical user interface (GUI) to set configuration



such as bandwidth allocation or firmware revision level.



Post-boot: Agent-free out-of-band or high-speed in-band connection over LOM through the

Operating System/BMC pass-through feature for sensory information.

Automation of firmware and driver version deployment upon component replacement.



Automatic monitoring of NIC status and notification on SNMP traps.

Local or remote re-configuration of any NIC, physical, or virtual.



PXE boot enabled on LOM for ease-of-use.



Boot from SAN (iSCSI, FCoE) configuration for networking devices through the Lifecycle

Controller GUI.

The M420 PCIe expansion connectors provide the following support:

Mezzanine Cards: A custom mezzanine connector that connects to a x8 PCIe 3.0 port.



The mezzanine card slot supports Fabric B or Fabric C, depending on the slot in the sleeve

where the blade is installed. This card must match the fabric type of the I/O modules installed

in the corresponding I/O module bays. Figure 6 illustrates the interconnectivity matrix and

Figure 7 illustrates interconnectivity examples for Fabric A and Fabrics B and C.

LOM: A custom network controller connector that connects to a x8 PCIe 3.0 slot.



LOM controller through a dedicated 1 x8 PCIe 2.0 or 3.0 compatible interface

Supports the embedded Broadcom 57810S-k 2P 10Gb

iDRAC7 shared LOM is not supported, the blade iDRAC has a dedicated 100Mbps link

Embedded PERC: A custom PERC + RIPS connector connects to a x4 PCIe slot.



PowerEdge M420 Technical Guide