Dell PowerEdge M600 매뉴얼 사용 - 페이지 32
{카테고리_이름} Dell PowerEdge M600에 대한 매뉴얼 사용을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge M600 44 페이지. Using dell blade servers in a dell poweredge high availability cluster
Dell PowerEdge M600에 대해서도 마찬가지입니다: 업데이트 매뉴얼 (44 페이지), 업데이트 매뉴얼 (21 페이지), 업데이트 매뉴얼 (14 페이지), 설치 매뉴얼 (7 페이지)
페이지 인쇄
Network-Attached Cluster
A network-attached cluster is a cluster configuration where all cluster nodes
are attached to a single storage system or to multiple storage systems through
a network using a redundant switch fabric. Network-attached cluster
configurations provide flexibility, expandability, and performance with either
iSCSI or Fibre Channel storage arrays.
Network-Attached Cluster Configured With an Internal Fabric
An internal fabric incorporates switch modules that do not connect to
external switches. Each server module I/O port is internally connected to a
port on a switch module. Up to two storage systems can be connected to the
outgoing ports on a switch module with internal fabric.
Cabling One PowerEdge Server Enclosure to One Storage System
In this configuration, a PowerEdge M1000e server enclosure is connected to
Dell|EMC CX3-20 storage system. The server and storage components in
your configuration may vary.
To cable one PowerEdge server enclosure to Dell|EMC CX3-20 storage
system:
1 Connect a cable from Fibre Channel switch module 1 to SP-A fibre port 0
(first fibre port).
2 Connect a cable from Fibre Channel switch module 1 to SP-B fibre port 1
(second fibre port).
3 Connect a cable from Fibre Channel switch module 2 to SP-A fibre port 1
(second fibre port).
4 Connect a cable from Fibre Channel switch module 2 to SP-B fibre port 0
(first fibre port).
Figure 2-3 shows how to cable a PowerEdge M1000e sever enclosure to the
CX3-20 storage system. The server module's dual-port Fibre Channel
daughter card and Fibre Channel switch modules are connected internally in
the system chassis.
32
Cabling Your Blade Cluster Hardware