Dell PowerEdge M620 기술 매뉴얼 - 페이지 40

{카테고리_이름} Dell PowerEdge M620에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge M620 44 페이지. Dell poweredge blade servers getting started guide
Dell PowerEdge M620에 대해서도 마찬가지입니다: 정보 업데이트 (38 페이지), 릴리스 정보 (27 페이지), 매뉴얼 (25 페이지), 사용자 설명서 (23 페이지), 중요 정보 매뉴얼 (35 페이지), 업데이트 매뉴얼 (32 페이지), 업데이트 매뉴얼 (28 페이지), 사용자 설명서 (26 페이지), 사용자 설명서 (22 페이지), 시작하기 매뉴얼 (12 페이지), 시작하기 매뉴얼 (12 페이지), 기술 매뉴얼 (46 페이지), 기술 매뉴얼 (49 페이지), 포트폴리오 매뉴얼 (27 페이지), 시작하기 매뉴얼 (14 페이지), 시작하기 매뉴얼 (12 페이지)

페이지 인쇄

Temperature and humidity

Expanded

operation

Storage

The Dell PowerEdge M620 iDRAC incorporates an integrated video subsystem. The graphics

controller is the 2D Matrox

RAM (256MB) device.

The M620 system supports the 2D graphics video modes in Table 24.

Resolution

640 x 480

800 x 600

1024 x 768

PowerEdge M620 Technical Guide

When operating in the expanded temperature range, system performance

may be impacted.

When operating in the expanded temperature range, ambient temperature

warnings may be reported on the LCD and in the System Event Log.

< 10% of annual operating hours: 5°C to 40°C at 5% to 85% RH with 26°C

dew point. Outside the standard operating temperature (10°C to 35°C), the

system can operate down to 5°C or up to 40°C for a maximum of 10% of its

annual operating hours. For temperatures between 35°C and 40°C, de-rate

maximum allowable dry bulb temperature by 1°C per 175 m above 950m

(1°F per 319 ft).

< 1% of annual operating hours: –5°C to 45°C at 5% to 90% RH with 26°C

dew point. Outside the standard operating temperature (10°C to 35°C), the

system can operate down to –5°C or up to 45°C for a maximum of 1% of its

annual operating hours. For temperatures between 40°C and 45°C, de-rate

maximum allowable dry bulb temperature by 1°C per 125m above 950m

(1°F per 228ft).

Expanded operating temperature restrictions:



Maximum 95W processor is supported.



Dell PERC H710 and H710P cards are not supported in dual-processor

configurations.



When populating the blade slots in the enclosure with only PowerEdge

M620 blades:

Dual-processor blade servers with PERC H310 cards cannot be

mixed with single-processor blades.

To support a PERC H310 card in a dual-processor configuration, the

blade slots in the M1000e enclosure must be installed with M620

blades or a combination of blade blanks and M620 blades.

The PowerEdge M620 blades must be installed with 97 mm wide

heat sinks.

Non Dell qualified peripheral cards and/or peripheral cards greater than

25W are not supported.

–40

C to 65

C (-40

to 149

C per hour

G200. The video frame buffer (16MB) is contained within the iDRAC

Refresh Rate (Hz)

60, 70

60, 75, 85

F) with a maximum temperature gradation of

Color Depth (bit)

8, 16, 32