Dell PowerEdge M820 Systems 사용자 설명서 - 페이지 12

{카테고리_이름} Dell PowerEdge M820 Systems에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge M820 Systems 26 페이지. Dell poweredge blade servers getting started guide
Dell PowerEdge M820 Systems에 대해서도 마찬가지입니다: 정보 업데이트 (38 페이지), 릴리스 정보 (27 페이지), 사용자 설명서 (23 페이지), 중요 정보 매뉴얼 (35 페이지), 업데이트 매뉴얼 (32 페이지), 업데이트 매뉴얼 (28 페이지), 사용자 설명서 (22 페이지), 시작하기 매뉴얼 (12 페이지), 소유자 매뉴얼 (3 페이지), 기술 매뉴얼 (46 페이지), 포트폴리오 매뉴얼 (27 페이지), 시작하기 매뉴얼 (14 페이지), 시작하기 매뉴얼 (12 페이지), 기술 매뉴얼 (47 페이지)

페이지 인쇄
Dell PowerEdge M820 Systems 사용자 설명서
Rev 1.00
3
Command Line Interface (CLI) Reference
10GbE PTM management is done via the 10GbE PTM CLI. You can use the commands described
in this section after successfully connecting to the 10GbE PTM CLI according to the procedure
described in
Section 2, "Connecting to the 10GbE PTM CLI," on page
3.1

CLI Privilege Levels

The 10GbE PTM supports the following user privilege levels:
• USER - Common user level, indicated by the # prompt
• ADMIN - Administrator level, indicated by the & prompt
Different commands are available in different privilege levels. The command reference indicates
the required privilege level for each command that requires a privilege level higher than USER.
3.2

Quick Reference

Table 5 provides a quick reference to the CLI commands:
Command name
General Commands
help
exit
login
Software Image Commands
show image ver
copy image from-file
Device Commands
show device temp
Port Commands
show port link
12
Table 5 - List of Commands
Short Description
Shows the list of available commands
Exit from the 10GbE PTM CLI
Change privilege level
Shows the software image version
Upload new software image to the 10GbE PTM
Shows the temperature of a specified device
Shows port link state
8.
Reference
Section 3.4.1, "help," on page 13
Section 3.4.2, "exit," on page 14
Section 3.4.3, "login (ADMIN)," on
page 14
Section 3.5.1, "show image ver," on
page 14
Section 3.5.2, "copy image from-file,"
on page 15
Section 3.6.1, "show device temp
(ADMIN)," on page 15
Section 3.7.1, "show port link," on
page 16
Software User's Manual