Dell poweredge VRTX 시작하기 매뉴얼 - 페이지 16

{카테고리_이름} Dell poweredge VRTX에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell poweredge VRTX 30 페이지. Server
Dell poweredge VRTX에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 릴리스 노트 (5 페이지), 시작하기 매뉴얼 (14 페이지), 빠른 시작 및 참조 매뉴얼 (2 페이지), 기술 매뉴얼 (45 페이지), 시작하기 (2 페이지)

FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Maintenance Projects\Dell

The Telnet session begins.

Retrieving an IP Address

By default, the switch receives its IP address dynamically via a DHCP server.

You can change the OOB port's IP , but you cannot delete it. and you can add

another IP address on the In-Band interface (port, port-channel or VLAN).

The In-Band IP address can also be received from the DHCP server.

Receiving an In-Band IP Address from a DHCP Server

When using the DHCP protocol to retrieve an IP address, the device acts as a

DHCP client. When the device is reset, the DHCP command is saved in the

configuration file, but the IP address is not.

To retrieve an IP address from a DHCP server, perform the following steps:

1 Select and connect any port to a DHCP server or to a subnet that has a

DHCP server on it.

2 Type the following commands to use the selected port for receiving the IP

address:

Assigning dynamic IP Addresses on a port:

console# configure

console(config)# interface gi0/1

console(config-if)# ip address dhcp

Assigning a dynamic IP Addresses on a VLAN:

console# configure

console(config)# interface vlan 1

console(config-if)# ip address dhcp

The interface receives the IP address automatically.

D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 3 / 6 / 1 3 - F O R P R O O F O N LY

Using the CLI

Plasma\GSG\Plasma_UGUsing_CLI.fm