Dell S3100 Series 시작하기 매뉴얼 - 페이지 45

{카테고리_이름} Dell S3100 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell S3100 Series 46 페이지.
Dell S3100 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (45 페이지), 시작하기 매뉴얼 (27 페이지)

페이지 인쇄

untagged interface

This command is available only in VLAN interfaces.

To view which interfaces are tagged or untagged and to view which VLAN the interfaces belong, use the

show vlan command. To view just the interfaces that are in Layer 2 mode, use the show interfaces

switchport command in EXEC Privilege mode or EXEC mode.

Assigning an IP Address to a VLAN

VLANs are a Layer 2 feature. For two physical interfaces on different VLANs to communicate, assign an IP

address to the VLANs to route traffic between the two interfaces.

The shutdown command in INTERFACE mode does not affect Layer 2 traffic on the interface.

NOTE: You cannot assign an IP address to the Default VLAN, which, by default, is VLAN 1. To assign

another VLAN ID to the Default VLAN, use the default vlan-id vlan-id command from the

configuration mode.

•

Access INTERFACE VLAN mode of the VLAN to which you want to assign the IP address.

INTERFACE mode

ip address ip-address mask [secondary]

Configure an IP address and mask on the interface.

Connect the System to the Network

After you have completed the hardware installation and software configuration for the system, connect

to your company network by following your company's cabling requirements.

Installing the Software