Dell S4048-ON 구성 매뉴얼 - 페이지 27

{카테고리_이름} Dell S4048-ON에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell S4048-ON 30 페이지. Enterprise switches
Dell S4048-ON에 대해서도 마찬가지입니다: 구성 매뉴얼 (19 페이지), 문제 해결 매뉴얼 (29 페이지)

페이지 인쇄

Switch configuration (OS 10.x)

3.3

Revert from DCB to non-DCB configuration (optional)

One method to revert from a DCB-configured switch to a non-DCB-configured switch is to delete the current

configuration (startup-config) and follow the steps in section 3.1. If deleting the current configuration is not an

option, use the following procedure to unconfigure DCB and enable standard flow control.

Note: This is a disruptive operation that requires downtime. The arrays will temporarily lose communication

with each other. Power off all arrays and hosts connected to the SAN before proceeding with these steps.

3.3.1

Disable DCB

OS10# configure terminal

OS10(config)# no dcbx enable

OS10(config)#

3.3.2

Disable iSCSI

OS10(config)# no iscsi enable

OS10(config)# no iscsi session-monitoring enable

3.3.3

Remove DCB policies and apply standard flow control on edge ports

OS10(config)# interface range ethernet 1/1/1-1/1/48

OS10(conf-range-eth1/1/1-1/1/48)# no priority-flow-control

OS10(conf-range-eth1/1/1-1/1/48)# no qos-map traffic-class

OS10(conf-range-eth1/1/1-1/1/48)# no ets

OS10(conf-range-eth1/1/1-1/1/48)# no service-policy output type queuing

<queuing-policy-name>

OS10(conf-range-eth1/1/1-1/1/48)# no service-policy input type network-qos

<policy-map-name>

OS10(conf-range-eth1/1/1-1/1/48)# no switchport trunk allowed vlan <vlan-id>

OS10(conf-range-eth1/1/1-1/1/48)# no switchport mode

OS10(conf-range-eth1/1/1-1/1/48)# switchport mode access

OS10(conf-range-eth1/1/1-1/1/48)# flowcontrol receive on

OS10(conf-range-eth1/1/1-1/1/48)# flowcontrol transmit off

OS10(conf-range-eth1/1/1-1/1/48)# exit

OS10(config)#

Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG1026