Dell S4248FB-ON 설치 매뉴얼 - 페이지 37
{카테고리_이름} Dell S4248FB-ON에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell S4248FB-ON 47 페이지. S4200-on series
Dell S4248FB-ON에 대해서도 마찬가지입니다: 설정 매뉴얼 (29 페이지)
페이지 인쇄
Besides the 10/100/1000Base-T RJ-45 ports, the S4200-ON Series (S4248FB-ON and S4248FBL-ON) switch provides several ports for
management and storage.
NOTE:
The output examples in this section are for reference only. Your output may vary.
Topics:
•
RS-232 console port access
•
USB storage mount
•
Before you install an OS
•
ONIE service discovery
RS-232 console port access
The RS-232 console port is on the I/O-side of the S4200-ON Series (S4248FB-ON and S4248FBL-ON) switch, as shown.
Figure 21. S4200-ON series RS-232 console port
CAUTION:
Ensure that any equipment attached to the serial port can support the required 115200 baud rate.
NOTE:
Before starting this procedure, ensure your PC has a 9-pin serial port. You must have a terminal emulation program
already installed and running on your PC.
NOTE:
If your PC's serial port cannot accept a female DB-9 connector, acquire a DB-9 male-to-male adaptor.
1
Install the provided RJ-45 connector side of the provided cable into the S4200-ON Series console port.
2
Install the DB-9 female side of the provided copper cable into your PC's serial port. Or install the DB-9 cable into other data terminal
equipment (DTE) server hardware that you intend to use.
3
Keep the default terminal settings on the console as follows:
•
115200 baud rate
•
No parity
•
8 data bits
•
1 stop bit
•
No flow control
Management ports
Management ports
8
37