Dell S4248FBL-ON 설치 매뉴얼 - 페이지 29

{카테고리_이름} Dell S4248FBL-ON에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell S4248FBL-ON 47 페이지. S4200-on series
Dell S4248FBL-ON에 대해서도 마찬가지입니다: 설정 매뉴얼 (29 페이지)

페이지 인쇄

1. Features

NOTE:

A US AC power cable is included for powering up an AC power supply. You must order all other power cables separately.

NOTE:

ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap when

handling the S4200-ON Series switch and its components.

Power up sequence

When the switch powers up, the fans immediately come on at high speed. The fan speed slows as the switch continues to boot up.

After switch installation

To configure your switch, after you have securely installed and powered on the S4200-ON Series switch, see your open network installation

environment (ONIE)-compatible operating system documentation at http://onie.org. For more information about working with the ONIE

environment, see your switch documentation at www.dell.com/support.

Switch replacement

The following steps describe removing and replacing a switch. For further assistance when replacing a switch, contact your Dell EMC

support representative.

NOTE:

ESD damage can occur when components are mishandled. Always wear an ESD-preventive wrist or heel ground strap

when handling the switch and accessories. After you remove the original packaging, place the switch and components on an anti-

static surface.

Back up the switch configuration to your back-up computer or laptop TFTP server.

copy running-config tftp://hostip/filepath

To establish a console connection to the switch CLI, assign an IP address on the switch network.

Disconnect the power source.

Label and remove all cables.

Remove the switch from the rack.

At the same time, press in the two side-release bars on the switch and slide the switch forward.

If you are using the fan trays or PSUs in the replacement switch, remove them from the switch.

Unpack the new switch.

For more information, see Unpack.

Confirm that the software version of the replacement switch is the same as the previously installed switch.

show os-version

If the software versions do not match, upgrade the replacement switch software using the procedure included with the firmware

download.

Copy the backed-up switch configuration to the new switch.

copy tftp://hostip/filepath running-config

Install the new switch in your rack or cabinet.

For detailed installation instructions, see

If you are using the fan trays or PSUs from the removed switch, reinsert them in the replacement switch.

Connect all the cables.

Power on the switch.

For more information, see

S4200-ON Series

Switch power

up.

installation.

S4200-ON Series installation