Dell Wyse R Class 매뉴얼 - 페이지 18

{카테고리_이름} Dell Wyse R Class에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Wyse R Class 29 페이지. Implementing fcoe in the linux operating system

페이지 인쇄
Dell Wyse R Class 매뉴얼
Implementing FCoE in the Linux Operating System
6. Finally, to determine the device names for your FCoE LUNs, run the cat /proc/partitions
command, as in Figure 14. In this example, the FCoE LUNs are listed as /dev/sdb and
/dev/sdc .
Partition and mount FCoE LUNs as any other hard disk device.

Configure the FCoE client to start at boot

If you want the FCoE client to start and the FCoE LUNs to automatically be available after every
reboot, configure the appropriate services using YaST2 by performing the following steps:
1. Start the YaST2 Control Center using the yast command, select Network Service , and then
FCoE Client Configuration , as in Figure 15.
Figure 14.
FCoE LUNs displayed.
18