Dell Wyse R Class 매뉴얼 - 페이지 26
{카테고리_이름} Dell Wyse R Class에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Wyse R Class 29 페이지. Implementing fcoe in the linux operating system
페이지 인쇄
Implementing FCoE in the Linux Operating System
4. After package installation is complete, you can then change back to the home directory and
unmount your installation media by running the cd ~ and umount /media command, as in
Figure 27.
Configuring the FCoE client VLAN
To configure the FCoE client VLAN, perform the following steps:
1. Change directory to /etc/fcoe , and copy the /etc/fcoe/cfg-ethx file to
/e4tc/fcoe/<interface> , where <interface> is the name of the specific network
interface over which FCoE traffic flows. In this example, we will use the interface name p3p1 .
See Figure 28 for details.
Figure 28.
2. Then edit the /etc/fcoe/cfg-p3p1 file and set DCB_REQUIRED variable to "no" , as in
Figure 29.
Figure 29.
3. Next, check the /etc/fcoe/config file, and verify that the SUPPORTED_DRIVERS variable
is set to "fcoe bnx2fc" , as in Figure 30.
Figure 27.
Unmounting the installation media.
Creating the FCoE Adapter Configuration file.
Setting the DCB_REQUIRED variable to "no".
26