Dell X1000 Series 시작하기 매뉴얼 - 페이지 7

{카테고리_이름} Dell X1000 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell X1000 Series 43 페이지.

Figure 1-1. Bracket Installation for Rack Mounting

2 Insert the supplied screws into the rack mounting holes and tighten with

a screwdriver.

3 Repeat the process for the rack-mounting bracket on the other side of the

switch.

4 Insert the switch into the rack, making sure the rack-mounting holes on

the switch line up to the mounting holes on the rack.

5 Secure the switch to the rack with the rack screws (not provided). Fasten

the lower pair of screws before the upper pair of screws. Make sure that the

ventilation holes are not obstructed.

Flat Surface Installation

The switch can be installed on a flat surface if it is not installed on a rack.

The surface must be able to support the weight of the switch and the switch

cables.

1 Attach the self-adhesive rubber pads (provided with the switch) on each

marked location on the bottom of the chassis.

2 Set the switch on a flat surface, while leaving two inches (5.08 cm) on each

side and five inches (12.7 cm) at the back.

Getting Started Guide