Dell Z9000 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} Dell Z9000에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Z9000 27 페이지. Z9000 system
Dell Z9000에 대해서도 마찬가지입니다: 매뉴얼 (48 페이지)

Installing the Hardware

Perform all site preparation before installing the Z9000 system.

Installing the Z9000 Chassis in a Rack or

Cabinet

To install the Z9000 system, Dell Force10 recommends completing the

installation procedures in the order presented in this chapter.

Always handle the system and its components with care. Avoid dropping the

Z9000 chassis or its Field Replaceable Units (FRUs).

For proper ventilation, position the Z9000 chassis in an equipment rack (or

cabinet) with a minimum of five inches (12.7 cm) of clearance around the

exhaust vents. When you install two Z9000 systems near each other, to permit

proper airflow, position the two chassis at least five inches (12.7 cm) apart. The

acceptable ambient temperature ranges are listed in

CAUTION: Electrostatic discharge (ESD) damage can occur if the

components are mishandled. Always wear an ESD-preventive wrist or heel

ground strap when handling the Z9000 and its components.

CAUTION: Take all the necessary safety precautions to prevent injury when

installing this system.

Attach the Mounting Brackets

The Z9000 system is shipped with mounting brackets (rack ears) and the

required screws for rack or cabinet installation. The brackets are enclosed in a

package with the system.

To attach the mounting brackets, follow these steps:

Step

Task

Take the brackets and screws out of their packaging.

Environmental

Parameters.

Installing the Hardware