Dell Z9000 매뉴얼 - 페이지 21
{카테고리_이름} Dell Z9000에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Z9000 48 페이지. Z9000 system
Dell Z9000에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (27 페이지)
페이지 인쇄
Figure 4. The SSD
Removing the Solid State Drive
To remove and replace an SSD, follow these steps.
1.
Shut down the system.
2.
Loosen the retaining screws on the SSD.
3.
Use the handle to pull the SSD out of the slot.
4.
Remove the SSD and set it aside.
5.
Use the SSD handle to slide the replacement SSD into the slot and firmly press it in place.
6.
Finger tighten the retaining screws.
7.
Restart the system.
Supply Power and Power Up the System
Supply power to the Z9000 after it is mounted in a rack or cabinet.
Dell Networking OS recommends re-inspecting your system prior to powering up. Verify that:
•
the equipment is properly secured to the rack and properly grounded.
•
the equipment rack is properly mounted and grounded.
•
the ambient temperature around the unit (which may be higher than the room temperature) is within
the limits specified for the Z9000.
•
there is sufficient airflow around the unit.
Install the Z9000
21