Dell Z9100-ON 설치 매뉴얼 - 페이지 31

{카테고리_이름} Dell Z9100-ON에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Z9100-ON 45 페이지. Open networking
Dell Z9100-ON에 대해서도 마찬가지입니다: 설치 매뉴얼 (45 페이지), 설치 매뉴얼 (43 페이지)

페이지 인쇄

NOTE:

Do not cross the wires—In the wiring block, RTN aligns with RTN and –48V aligns with –48V.

5. Insert the DC power connector into the power socket of the DC PSU. Ensure that the connector pins firmly seat and you

hear the click of the power connector's left and right levered clamps lock into place.

NOTE:

Never try to force the power connector into or out of the DC PSU power socket.

NOTE:

To remove the power connector from a DC PSU, use the orange tab on the side of the connector. Doing so

disengages the power connector's clamps. After engaging the orange tab, pull the power connector from the DC PSU

socket.

AC or DC power supply replacement

CAUTION:

Disconnect the power cable before removing the power supplies. Also, disconnect all power cables

before servicing.

NOTE:

The PSU slides into the slot smoothly. Do not force a PSU into a slot as this action may damage the PSU or the

Z9100–ON switch.

NOTE:

If a PSU fails, you must replace the entire unit. There are no field serviceable components in the PSU. To request a

hardware replacement, see

NOTE:

If you use a single PSU, install a blank plate in the other PSU slot. If you are only using one power supply, install the

power supply in the first slot, PSU1. Install a blank plate in the second slot, PSU2.

1. Disconnect the power cable from the PSU.

2. Use the grab handle to slide the PSU out of the power supply bay.

3. Use the grab handle on the replacement PSU to slide it into the power supply bay.

4. Attach the power cable to the replacement PSU.

NOTE:

The switch powers up when the cables are connected between the power supply and the power source.

Dell

Support.

Power supplies