Dell Z9100-ON 설치 매뉴얼 - 페이지 36

{카테고리_이름} Dell Z9100-ON에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Z9100-ON 45 페이지. Open networking
Dell Z9100-ON에 대해서도 마찬가지입니다: 설치 매뉴얼 (45 페이지), 설치 매뉴얼 (43 페이지)

페이지 인쇄

MicroUSB-B console port access

The MicroUSB type B console port is on the I/O side of the switch.

NOTE:

The Z9100-ON switch uses the Silicon Labs CP2102 USB-B chip. To find the correct USB-B universal

asynchronous receiver-transmitter (UART) driver, see

usb-to-uart-bridge-vcp-drivers.

When you connect the MicroUSB-B port, it becomes the primary connection and, while connected, all messages are sent to the

microUSB-B port.

1. Power on the PC.

2. Connect the USB-A end of cable into an available USB port on the PC.

3. Connect the microUSB-B end of cable into the microUSB-B console port on the Z9100-ON.

4. Power on the switch.

5. Install the necessary USB device drivers.

6. Open your terminal software emulation program to access the Z9100-ON.

7. Confirm that the terminal settings on your terminal software emulation program are as follows:

● 115200 baud rate

● No parity

● 8 data bits

● 1 stop bit

● No flow control

USB storage

USB storage supports the FAT file system. USB storage does not automatically mount, to use USB storage, first mount the

device.

1. Create a mount directory for the USB storage.

ONIE:/ # mkdir /mnt/usb

2. View the fixed disks using the fdisk command.

ONIE:/mnt # fdisk -l

For internal storage:

Disk /dev/sda: 15.8 GB, 15829303296 bytes

255 heads, 63 sectors/track, 1924 cylinders

Units = cylinders of 16065 * 512 = 8225280 bytes

Device Boot

/dev/sda1

For USB storage:

Disk /dev/sdb: 30.9 GB, 30942946304 bytes

64 heads, 32 sectors/track, 29509 cylinders

Units = cylinders of 2048 * 512 = 1048576 bytes

Device Boot

3. Mount the device /dev/sdb to the /mnt/usb directory.

ONIE:/ # mount -t vfat /dev/sdb /mnt/usb

NOTE:

The following message displays if the /mnt/usb directory is missing: mount: mounting /dev/sdb

on /mnt/usb failed: No such file or directory.

NOTE:

The following message displays if the USB device is not seen: mount: mounting /dev/sdb on /mnt/usb

failed: No such device or address.

Management ports

Start

End

1925

Start

End

https://www.silabs.com/products/development-tools/software/

Blocks

Id System

15458303+ ee EFI GPT

Blocks

Id System