AVYCON AVC-NBL41M-L1 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} AVYCON AVC-NBL41M-L1에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AVYCON AVC-NBL41M-L1 2 페이지.

페이지 인쇄

② Route the cables and connect the relevant cables. Then fasten the

mounting base to the wall with the screws and drywall anchors in

the package.

Drywall Anchors

Mounting Base

Mounting Screws

③ To adjust the bracket, ﬁrst preview the image of the camera on a

monitor and then loosen the lock screws with the wrench to adjust

the view angle of the camera. Then tighten the lock screws in place.

Lock Screws

Pan: 360°

Tilt: 90°

Rotate: 360°

④ Open the cover of the camera as shown in the following ﬁgure and

insert a micro SD card.

⑤

Press T/W button to adjust the zoom levels and obtain an optimal

image on the screen.

Micro SD Card

Cover

Zoom +

*Only some models support T&W buttons. If your camera doesn't have these two buttons, please skip

⑤

step

⑥

Finish installation by ﬁxing the cover back onto the camera ﬁrmly with the

mounting screws (make sure cover is installed on evenly).

Mounting Template

5. NETWORK CONNECTION

In LAN, there are two ways to access the camera:

1. Access Through IP-Tool

2. Direct Access Through WEB Browser

IPC

Wrench

① Make sure that the camera and the PC are connected to the local network.

② Install IP-Tool from the CD and run it after installation.

Zoom -

Switch

Network Cable

Router

Computer

③ Modifying the IP address: The default IP address of this camera is

192.168.226.201. Click on the row of the camera listed in the above

table to show the network information on the right hand. Modify the

IP address and gateway of the camera and make sure its network

address is in the same local network segment as the recorder's.

For example, if the IP address of your computer is 192.168.1.4, then you

will need to modify the IP address of the camera to 192.168.1.x. After

modifying, please enter the password of the administrator and click the

"Modify" button to modify the IP settings.

The default password of the administrator is "123456"

④ Double-click the camera listed in the IP-Tool or manually enter the IP

address in the address bar of the web browser to connect IP camera.

Then follow directions to download and install the plugin.

⑤ Enter the username and password in the login interface.

DIRECT ACCESS THROUGH WEB BROWSER

① Make sure that the camera and the PC are connected via LAN.

② Find the IP-Tool from the CD and then install the program onto your

computer. Run the IP-Tool program.

③ Modify the IP address and make sure its network address is in the

same local network segment as the computer's.

④ Open your web browser and enter the modiﬁed IP address into the

address bar to login to the web client. Follow directions to download

the plugin to your computer. After that, enter the default username

and password to login.