AVYCON AVR NT832A 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} AVYCON AVR NT832A에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AVYCON AVR NT832A 11 페이지.

6 System Login

You must conﬁgure the wizard if you start the DVR for the ﬁrst time. Choose the language.

Then set the data, time and zone as needed. After that, set the login password.

The default username is admin. Set your own password when you use the wizard for the

ﬁrst time. Enable pattern lock and click "Edit" to set the pattern lock. Then set security

questions and answers. It is important for you to remember these answers, or you will not

be able to reset your password. Click "Next" to continue.

You can view the disk number, disk capacity of the DVR and serial number, Read/Write

status of the disk. Click "Format" to format the disk. Click "Next" to continue.

8 Network Conﬁguration & Add IP Camera

① Select the work pattern and then enter IP address, subnet mask, gateway, etc. If using

DHCP, please enable DHCP in both the DVR and the router.

The multiple address setting or network fault tolerance can be chosen and conﬁgured.

Network Fault Tolerance: Bind two network ports to one IP address. This pattern can

increase the network bandwidth and form a network redundant array to share the load.

When one port goes wrong, the other port will take over the entire load immediately

and seamlessly.

Multiple Address Setting: You shall set the IP address, subnet mask, gateway and DNS

of each Ethernet port respectively.

NETWORK VIDEO RECORDER | AVR SERIES | SYSTEM LOGIN

Admin Password Setup

Username

admin

xxxxxx

New Password

xxxxxx

Confirm Password

Display Password

Pattern Lock

Enable

Wizard

Edit