EarthQuake Granite-52 사용자 설명서 - 페이지 8

{카테고리_이름} EarthQuake Granite-52에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthQuake Granite-52 12 페이지. Limestone & granite rock-on series
EarthQuake Granite-52에 대해서도 마찬가지입니다: 사용자 설명서 (10 페이지)

페이지 인쇄

Unpacking & Wiring

Unpacking system components

• Keep the original carton and packing materials for future

shipment or storage.

• Check for any visual signs of damage. If you encounter any

concealed damage, consult your Earthquake Sound dealer

before proceeding with unit installation.

• Retain the sales receipt as it established the duration of the

limited warranty and provided information for insurance

purposes.

System installation considerations

There are several factors to consider before installing Earthquake

Sound's

ROCK-on series

• What are the intended listening zones?

• What system options and accessories might be required for

features such as local sources, etc.?

• From where in each zone will the listener prefer to control the

system? Where will the remote gains be located? Where will the

speakers be located?

• Where will the source equipment be located?

Connection tips

• Keep all power cords away from all signal cables to prevent

humming from induced noise.

• Choose reliable signal cables cords (Earthquake Sound also

specializes in high-performance RCA cables and patches).

• All speaker wires that are ran through the walls should be twisted

type to reduce potential hum noise pick up.

• It is best to use a grounded electrical outlet to power the

amplifier. Lack of input ground reference could be unsafe.

Consult with your electrical contractor about proper grounding.

Wiring Your System

1. Use direct burial wire and measure out how much you will need.

2. Dig a 6-inch deep trench to each speaker.

3. Connect the speaker wire to the speaker. It is recommended that you use heat-shrink tubing to seal each individual

conductor, then heat-shrink the two connections together.

Make sure that all connections are secure. A poor connection can lead to corrosion and a damaged

speaker.

4. Run the wire through the trench to the amplifier.

5. Connect the speaker wire to the terminals on the back of your amplifier.

Make sure that the speaker wires' polarity is connected correctly.

+ (positive, red) to speaker red wire (positive)

– (negative, black) to speaker black wire (negative)

6. Turn your amplifier on and test the system with your favorite music. If the speakers are operating properly, refill the

trench.

-8-

Earthquake Sound Corp. | (800) 576-7944 | www.earthquakesound.com