EarthQuake Kompressor S-10 기술 매뉴얼 - 페이지 5

{카테고리_이름} EarthQuake Kompressor S-10에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthQuake Kompressor S-10 10 페이지. Front firing powered subwoofers

Connecting Your Subwoofer

Low level -RCA- audio input connection:

This is the best way to drive an audio signal into the Kompressor

subwoofer. Today, all signal processors(5.1/6.1 and more advanced ones)

come equipped with built-in pre-amplifier outputs (RCA) that include a

subwoofer output.

Generally, the SUB/OUT is in mono format. As shown in the

photos across, connect the SUB/OUT from the processor to the

Kompressor using a "Y" connector to feed both RCA inputs of the

subwoofer.

We strongly recommend that you use the best available RCA

connectors and cables. High quality cables are normally triple shielded,

and the connectors are gold plated with forceful grasping (refer to

Earthquake line of accessories- SI superior Interconnect - at

www.earthquakesound.com).

High level audio input connection:

This is the least desired way to drive an

audio signal into the subwoofer. Older stereo systems

are not equipped with pre-amplifier audio outputs,

normally they come with stereo speaker outputs (left

& right).

Using "banana" plugs, connect the speaker

outputs to the corresponding Subwoofer high level

inputs (marked "FROM RECEIVER). In this

configuration, the front stereo speakers (towers) can

be powered up by connecting them to the subwoofer

speaker outputs (marked "TO SPEAKERS"). The

amount of power (watts) driven into the stereo

speakers (towers) is identical to the amount of power

(watts) fed into the SuperNova from the stereo system

(ratio 1:1).

AC power connection:

The SuperNova subwoofer is available in two models:

110V and 220V/24. The power socket if fused to protect the

amplifier from surges. Do not overfuse, replace the fuse with

identical value.

RCA connection from Processor to

a Kompressor using a "Y" connector.

-6-