EarthQuake MiniMe FF8 사용자 설명서 - 페이지 8

{카테고리_이름} EarthQuake MiniMe FF8에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthQuake MiniMe FF8 16 페이지.

Connections

Please consider the following when setting up

your new system:

• Before making or changing any connections,

ALWAYS make sure that the subwoofer is unplugged

from the wall and your other components are turned

OFF. Also, turn down the volume control of the

subwoofer and your pre-amplifier or receiver.

AC outlets on the same circuit breaker

• This diagram shows all the low power components

sharing a power strip which is connected to the same

outlet used by the amplifier.

• The subwoofer is connected to an outlet on the

same circuit breaker, provided that the total system

current draw does not exceed the breaker current

rating.

• This arrangement will reduce the possibility of an

audible hum in your system caused by a ground loop.

• Whenever possible, keep the power cords away

from the signal cable or speaker wires to prevent any

hum or inference being heard in speakers.

Earthquake • MiniMe User Manual

Tape Deck

DVD

Pre-amplifier

Power strip

Amplifier

Subwoofer

• Choose reliable, high quality interconnect cables,

also called patch cords or RCA cables. They should

be fully shielded and as short as possible for the job.

The longest cable in your system will likely be to the

subwoofer, so choose a good quality brand.

• Some patch cords can be a very tight fit and there is

usually a preferred method of getting them off. Some

have to be re=moved with a twisting action. Be gentle

or you may damage the jacks of the subwoofer or

your other components.

Speaker Level Connections

• The subwoofer's Speaker Level Inputs can accept

speaker stripped speaker wires only.

• Make sure that the negative speaker wires never

touch the positive wires as this will short out and

possibly damage your amplifier or receiver.