EarthQuake MC440 운영자 매뉴얼 - 페이지 3

{카테고리_이름} EarthQuake MC440에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthQuake MC440 3 페이지. 4-cycle cultivator
EarthQuake MC440에 대해서도 마찬가지입니다: 운영자 매뉴얼 (2 페이지), 운영자 매뉴얼 (7 페이지)

페이지 인쇄

warranted for the remainder of the ECS Warranty Period.

(2) Any warranted, emissions-related part that is scheduled only

for regular inspection as specified in the Maintenance Schedule

(located in the section of the Manual(s) pertaining to maintenance)

shall be warranted for the ECS Warranty Period. A statement in such

written instructions to the effect of "repair or replace as necessary"

shall not reduce the ECS Warranty Period. Any such part repaired

or replaced under the ECS Warranty shall be warranted for the

remainder of the ECS Warranty Period.

(3) Any warranted, emissions-related part that is scheduled

for replacement as required maintenance in the Maintenance

Schedule (located in the section of the Manual(s) pertaining to

maintenance) shall be warranted for the period of time prior to the

first scheduled replacement point for that part. If the part fails prior

to the first scheduled replacement, the part shall be repaired or

replaced by Ardisam according to Subsection (4) below. Any such

emissions-related part repaired or replaced under the ECS Warranty

shall be warranted for the remainder of the ECS Warranty Period

prior to the first scheduled replacement point for such emissions-

related part.

(4) Repair or replacement of any warranted, emissions-related part

under this ECS Warranty shall be performed at no charge to the

owner at a Ardisam Authorized Warranty Service Facility.

(5) When the engine is inspected by a Ardisam Authorized Warranty

Service Facility, the owner shall not be held responsible for

diagnostic costs if the repair is deemed warrantable.

(6) Ardisam shall be liable for damages to other original engine

components or approved modifications proximately caused by a

failure under warranty of any emission-related part covered by the

ECS Warranty.

(7) Throughout the ECS Warranty Period, Ardisam shall maintain a

supply of warranted emission-related parts sufficient to meet the

expected demand for such emission-related parts.

(8) Any Ardisam authorized and approved emission-related

replacement part may be used in the performance of any ECS

Warranty maintenance or repairs and will be provided without

charge to the purchaser/owner. Such use shall not reduce Ardisam's

ECS Warranty obligations.

(9) Unapproved, add-on, modified, counterfeit and/or "grey market"

parts may not be used to modify or repair a Ardisam engine. Such

use voids this ECS Warranty and shall be sufficient grounds for

disallowing an ECS Warranty claim. Ardisam shall not be held liable

Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5

hereunder for failures of any warranted parts of a Ardisam engine

caused by the use of such an unapproved, add-on, modified,

counterfeit and/or "grey market" part.

EMISSION-RELATED PARTS INCLUDE THE FOLLOWING

(IF EQUIPPED):

(1) Fuel Metering System

(i) Carburetor and internal parts (and/or pressure regulator or

fuel injection system).

(ii) Air/fuel ratio feedback and control system.

(iii) Cold start enrichment system.

(iv) Fuel Tank.

(2) Air Induction System

(i) Controlled hot air intake system.

(ii) Intake manifold.

(iii) Air filter.

(3) Ignition System

(i) Spark Plugs.

(ii) Magneto or electronic ignition system.

(iii) Spark advance/retard system.

(4) Exhaust Gas Recirculation (EGR) System

(i) EGR valve body, and carburetor spacer if applicable.

(ii) EGR rate feedback and control system.

(5) Air Injection System

(i) Air pump or pulse valve.

(ii) Valves affecting distribution of flow.

(iii) Distribution manifold.

(6) Catalyst or Thermal Reactor System

(i) Catalytic converter.

(ii) Thermal reactor.

(iii) Exhaust manifold.

(7) Particulate Controls

(i) Traps, filters, precipitators, and any other device used to

capture particulate emissions.

(8) Miscellaneous Items Used in Above Systems

(i) Electronic controls.

(ii) Vacuum, temperature, and time sensitive valves and

switches.

(iii) Hoses, belts, connectors, and assemblies.

Operator's Manual

MC440 4-Cycle Cultivator