AW-Lake M9480220 설치 운영 및 유지보수 매뉴얼 - 페이지 7
{카테고리_이름} AW-Lake M9480220에 대한 설치 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AW-Lake M9480220 18 페이지. The edge flow sensor with bluetooth
페이지 인쇄
Figure 3: Setup Menu
Menu Navigation
Press the three lines in the top right corner to access the setup menu
(Figure 3)
System Settings: Adjust K-factor, Filter, Flow Units, Flow Time Base,
Max Flow Rate, Max Flow Units, Max Time Base, and Bluetooth name
Output Settings: Where outputs can be forced to certain
values or output type can be selected
(Voltage type only)
Output Calibration: Calibrate analog outputs
(consult factory)
Linearizer Table: Allows user to select custom K-factors for different
points on the flow range
Diagnostics: Shows raw input frequency
About Bluetooth Device: Displays device type, Bluetooth name, firmware version, and serial
number
Disconnect: Used to disconnect from device
Exit: Closes application
System Settings
Figure 4: System Settings
This menu allows users to scale the EDGE to output correct analog
signal and display correct flow rate in the desired units and time
base. It will also allow for filtering of the output. (Figure 4)
*After any option is changed press SET for it to take effect.
Use back button on phone to return to main screen.*
K-factor:
The flow meter scaling factor in pulses/gal (found on
calibration sheet)
Digital Filter:
Smooth out erratic input frequency. Only effects
analog signals. There are four options to choose from;
7 |
P a g e