EarthQuake PH10000W/D1 소유자 매뉴얼 - 페이지 7

{카테고리_이름} EarthQuake PH10000W/D1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthQuake PH10000W/D1 10 페이지. Powerhouse series amplifiers
EarthQuake PH10000W/D1에 대해서도 마찬가지입니다: 브로셔 (8 페이지), 소유자 매뉴얼 (11 페이지), 소유자 매뉴얼 (10 페이지)

페이지 인쇄

PH2000W/ 1

PH2000W/ 1.1

Variable 10dB boost at 40Hz.

Perfect tool for high SPL scores.

Full time low-pass variable filter

12dB/Oct slope, range from 50

to 300Hz

Before you install the amp, take note of the following:

#1. You have to confirm that your power supply can

deliver spontaneous power to the amplifier when

needed to propel the load.

#2. Bullet-proof ground: the ground cable must be 4-

gauge minimum, it should be very short, and well

grounded to the chassis.

To battery (+)

To remote turn on / trigger

Three 25A Fuses

To car chassis / ground

Specifications Are Subject To Change Without Notice

Through output feeds other

amplifiers in the audio system.

NOT EFFECTED BY THE LOW-

PASS FILTER.

The gain knob is not a volume control.

It is designed to match the input level

of the amp to the output level of the

source unit. Over driving -clipping- the

input stage of the amp will cause

damage to the amplifier (Please refer

to table for settings).

BAT

REM GND

POWER

* Test the alternator output. Factory alternators will produce 60-80 amperes at best. Wear and

heat will reduce the output by 40%.

* Alternator ground (-) must be reinforced, use 4-gauge cable instead of the factory 8-gauge.

* Alternator positive (+) to battery (+) must be reinforced. Use 4-gauge cables.

* Check your battery condition. Batteries degrade after a while.

* Battery (+) to amplifier (+) must be a 4-gauge cable.

* Ground amplifier to chassis using 4-gauge cable, keep the cable short (Maximum 2-feet).

* Use 1 farad capacitor to compensate for surges in demand.

* We recommend the use of one (1) auxiliary battery.

Two Single 4-Ohm Subwoofers @ 2-Ohm

Two Dual 4-Ohm Subwoofers @ 1-Ohm

USE THREE 25-

AMPERE FUSES

TO PROTECT THE

AMPLIFIER

THIS CONFIGURATION

IS FOR USE WITH

PH2000W/D11 1-Ohm

AMPLIFIER ONLY